4 ] Installing The Battery Terminals; 5 ] Installing The Terminal Press Cover - Brother P-touch PT-1180 Service Manual

[ 4 ] Installing the battery terminals
(1) Put three battery terminals A (+,-) into the bottom cover from the direction of arrow.
(2) Turn the bottom cover upside down and fit the battery terminal (+) of the battery harness
ASSY into the bottom cover.
(3) Put two battery terminals B (+,-) into the bottom cover from the same direction.
Note1: When installing the battery terminals, set them into the grooves certainly.
Make sure to fit the all terminals completely.
Note2: Fit the battery terminal (+) firmly at the bottom. Further, make sure that the battery terminal
(+) does not contact with the battery terminals B (+,-).
[ 5 ] Installing the terminal press cover
(1) Install the battery terminal (-) to the terminal press cover as shown below.
(2) Push the terminal press cover along the groove of the bottom cover, until the two hooks are
locked certainly.
Battery terminal (-)
Bottom cover
Battery terminals A (+,-)
Fig. 2.2-21 Installing the Battery Terminals
Fig. 2.2-22 Installing the Terminal Pressure Cover
II-
Bottom cover
Terminal press cover
Groove
21
Battery terminals B (+,-)
Battery terminal (+)
Bottom cover