Brother P-touch PT-1180 Service Manual page 47

9.2.7. MOTOR Mode "7" Key: Used for the DC motor speed adjustment.
This mode is used only when the print length accuracy or tape feed length accuracy
deviates from the specification.
Display of Fig. 20 is indicated when depressed "7" key.
The function (MOTOR rotation) is started when depressed "
will not be turned to off in this case. The "On/Off (
When you failed, peel off the yellow "+" volume (VR1) by the cassette sensor switch
actuators as shown below. And insert a screwdriver to adjust the length of the tape by
rotating a trimmer.
If rotating the trimmer to the right (CW), the length becomens short.
If rotating to the left (CCW), it becomes long.
After the adjustment, verify the tape length and printed letter length by performing the
PRINT 1 or PRINT 2 functions.
Yellow "+" volume (VR1)
10 This machine becomes formatted, if you discharge the electricity after removing the AC
adapter and the batterries. (Refer to Format in the 1.3.1)
M T R
Fig. 20
Fig. 21
II- 32
" key. The electrical power
)" key is depressed to stop.
Bottom cover