Removing The Sub Assy Inlet - Brother P-touch QL-710W Service Manual
High-speed label printer
Hide thumbs
Also See for P-touch QL-710W:
- Quick setup manual (93 pages) ,
- Network user's manual (48 pages) ,
- Software user's manual (48 pages)
Table of Contents
Advertisement
[7]
Removing the Sub ASSY Inlet
(1) Unsolder the solder of the sub ASSY inlet harness from the power supply ASSY.
Sub ASSY inlet harness
(2) Release the hooks on both sides of the sub ASSY inlet and pull the inlet to the
direction of the arrow as shown in the figure below to remove it from the under
cover.
Sub ASSY inlet
Fig. 3.4-23 Removing the Sub ASSY Inlet (1)
Hooks
Fig. 3.4-24 Removing the Sub ASSY Inlet (2)
III - 19
Power supply ASSY
Sub ASSY
inlet harness
<Bottom side view>
Under cover
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
