GE GTDS855GDMC Installation Instructions Manual page 14

REVERSING THE DOOR SWING
13
SOLID DOOR MODELS
WITH COVER CAPS:
Open the door to approximately 170 degrees.
1
With a putty knife, remove the 4 plastic covers located
along the left side of front panel and set them aside.
Plastic Cap (4)
Remove the bottom screw from each hinge (right side)
2
and partially insert the, into the top left side hinge holes.
NOTE: All 4 front panel hinge screws will now be in the
top hinge holes - 2 on the left and 2 on the right.
Installation Instructions
Loosen the bottom 2 right side hinge screws. Remove
3
any damage. Remove both the Blind Plate and the Strike
Plate and install them in opposite positions.
Remove the 4 door hinge screws, 8 edge screws, and 4
4
blade screwdriver.
14