Reversing The Door Swing - GE GTDS855GDMC Installation Instructions Manual

REVERSING THE DOOR SWING

14
GLASS PANEL DOOR MODELS:
GTDS810ED0WS
GTDS810GD0WS
GTDS815ED0MC
GTDS815GD0MC
GTDS820ED0WS
GTDS820GD0WS
GTDS825ED0MC
GTDS825GD0MC
GHDS830ED0WS
GHDS830GD0WS
Open the door to approximately 170 degrees.
1
With a putty knife, remove the 4 plastic covers located
along the left side of front panel and set them aside.
Plastic Cap (4)
Remove the bottom screw from each hinge (right side)
2
and partially insert them into the top left side hinge
holes.
NOTE: All 4 front panel hinge screws will now be in the
top hinge holes - 2 on the left and 2 on the right.
Installation Instructions
GHDS835ED0MC
GHDS835GD0MC
GTDS850ED0WS
GTDS850GD0WS
GTDS855ED0MC
GTDS855GD0MC
GTDS860ED0WS
GTDS860GD0WS
GTDS865ED0MC
GTDS865GD0MC
Loosen the bottom 2 right side hinge screws. Remove the
3
damage.
Remove both the Blind Plate and the Strike Plate and
install them in opposite positions.
Remove the 4 door hinge screws, 4 edge screws, and
4
blade screwdriver.
Door hinge
screws
16
Inside screws
Inner door
Inside screws
Outer door
Edge
screws