GE GTDS855GDMC Installation Instructions Manual page 13

Remove and swap the 2 cover caps and door handle
5
from the outer door:
A. Squeeze the tabs on the inside of the door handle
clips. Push clips through the outer door.
B. Squeeze the tabs on the inside of the cover caps.
Push caps through the outer door.
C. Push the door handle clips into the openings on the
the handle so it curves to the inside.
D. Push the cover caps into the openings on the outer
door where the handle was removed.
Installation Instructions
When the cover caps and door handle in place, mount
6
the inner door back into the outer door with the screws
removed in step 4. Make sure you mount the hinges on
the side opposite the handle.
Mount the assembled door on the 2 upper left side hinge
7
screws installed in step 2.
Move the hinge screws loosened in step 3 into the lower
Install the 4 plastic caps removed in step 1 into the 4
8
right side front panel holes.
NOTE: To return the door to the original setup, follow
these instructions, swapping "left" and "right".
13