Table of Contents
Advertisement
5.1.2
Installing hard disk drives
The motherboard supports SATA hard disk drives for RAID set configuration. For
optimal performance, install identical drives of the same model and capacity when
creating a disk array.
See section 2.6 Hard disk drives for SATA hard disk drive installation.
5.1.3
Setting the RAID item in BIOS
You must enable the RAID function in the BIOS Setup before creating RAID set(s)
using SATA HDDs. To do this:
1.
Enter the BIOS Setup during POST.
Go to the Main menu > Storage Configuration, and then press <Enter>.
2.
Set the Configure SATA as item to [RAID].
3.
4.
Save your changes, and then exit the BIOS Setup.
Refer to Chapter 4 for details on entering and navigating through the BIOS
Setup.
ASUS TS100-E7/PI4
5-3
Advertisement
Table of Contents
