Table of Contents
Advertisement
4.5.11
APM
Aptio Setup Utility - Copyright (C) 2010 American Megatrends, Inc.
Restrore AC Power Loss
EuP Ready
Power On By PCI
Power On By PCIE
Power On By Ring
Power On By RTC
Restore AC Power Loss [Power Off]
When set to [Power Off], the system goes into off state after an AC power loss.
When set to [Power On], the system will reboot after an AC power loss. When set
to [Last State], the system goes into either off or on state, whatever the system
state was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
EuP Ready [Disabled]
When set to [Enabled], all other PME options will be switched off.
Configuration options: [Disabled] [Enabled]
This item is available on selected models.
Power On By PCI [Disabled]
[Disabled]
[Enabled]
Power On By PCIE [Disabled]
[Disabled]
[Enabled]
Power On By Ring [Disabled]
[Disabled]
[Enabled]
Power On By RTC [Disabled]
[Disabled]
[Enabled]
4-22
Advanced
[Power Off]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
Disables the PME to wake up from S5 by PCI devices.
Allows you to turn on the system through a PCI LAN or modem
card. This feature requires an ATX power supply that provides at
least 1A on the +5VSB lead.
Disables the PCIE devices to generate a wake event.
Enables the PCIE devices to generate a wake event.
Disables Ring to generate a wake event.
Enables Ring to generate a wake event.
Disables RTC to generate a wake event.
When set to [Enabled], the items RTC Alarm Date (Days) and
Hour/Minute/Second will become user-configurable with set
values.
Specify what state to go to
when power is re-applied after
a power failure (G3 state).
Chapter 4: BIOS setup
Advertisement
Table of Contents
