Sata Configuration - Asus TS100-E7/PI4 User Manual

Hide thumbs Also See for TS100-E7/PI4:
Table of Contents

Advertisement

4.5.7
SATA Configuration
While entering Setup, the BIOS automatically detects the presence of SATA
devices. The SATA Port items show Not Present if no SATA device is installed to
the corresponding SATA port.
Aptio Setup Utility - Copyright (C) 2010 American Megatrends, Inc.

SATA Configuration

SATA Mode
Serial-ATA Controller 0
Serial-ATA Controller 1
S.M.A.R.T. Status Check
SATA Port1
SATA Port2
SATA Port3
SATA Port4
SATA Port5
SATA Port6
SATA Mode [IDE Mode]
Allows you to set the SATA configuration.
Configuration options: [Disabled] [IDE Mode] [AHCI Mode] [RAID Mode]
Serial-ATA Controller 0 [Enhanced]
This item appears only when you set the SATA Mode item to [IDE Mode]. Set to
[Enhanced] to support four SATA 3.0 Gb/s devices. Set to [Compatible] when using
Windows 98/NT/2000/MS-DOS. Up to four SATA devices are supported under
these operating systems.
Serial-ATA Controller 1 [Enhanced]
This item appears only when you set the SATA Mode item to [IDE Mode]. Set to
[Enhanced] to support two SATA 3.0 Gb/s devices.
S.M.A.R.T. Status Check [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor
system. When read/write of your hard disk errors occur, this feature allows the hard
disk to report warning messages during the POST.
Configuration options: [Enabled] [Disabled]
4-18
Advanced
[IDE Mode]
[Enhanced]
[Enhanced]
[Enabled]
If you want to use the Serial ATA hard disk drives as Parallel ATA physical
storage devices, keep the default setting [IDE Mode].
If you want the Serial ATA hard disk drives to use the Advanced Host
Controller Interface (AHCI), set this item to [AHCI Mode]. The AHCI allows
the onboard storage driver to enable advanced Serial ATA features that
increases storage performance on random workloads by allowing the drive
to internally optimize the order of commands.
If you want to create RAID sets with LSI MegaRAID utility, or Intel
Storage Technology from the Serial ATA hard disk drives, set this item to
[RAID Mode].
ST3160812AS (160.0GB)
ST3160812AS (160.0GB)
ASUS CB-521 ATAPI
Not Present
Not Present
Not Present
(1) IDE Mode. (2) AHCI Mode.
(3) RAID Mode.
®
Chapter 4: BIOS setup
Rapid

Advertisement

Table of Contents
loading

Table of Contents