Table of Contents
Advertisement
EFFECT
DIVIDER
Within the effect chain, the point where the signal is split into channels
"A" and "B" is called the "divider, " and the point where the two signals are
recombined is called the "mixer . "
You can use the divider to switch between channels "A" and "B, " to assign
strongly picked notes and softly picked notes to different channels, or
to assign different frequency bands of your guitar sound to different
channels .
The mixer lets you adjust the volume balance of channels "A" and "B, "
place them in the stereo field, or slightly delay the sound of channel "B" to
produce a spacious sound .
DIVIDER
Parameter
Value
SINGLE
MODE
DUAL
SINGLE
Parameter
Value
CH SELECT
Ch . A, Ch . B
DUAL Ch. A, DUAL Ch. B
Parameter
Value
OFF
Ch . A/Ch . B
POLAR+
DYNAMIC
POLAR-
Ch . A/Ch . B
DYNAMIC
0–100
SENS
OFF
Ch . A/Ch . B
LPF
FILTER
HPF
Ch . A/Ch . B
100 Hz–2 kHz
CUTOFF FREQ
22
MIXER
Explanation
Use only one channel, either "A" or "B . "
Use the two channels "A" and "B . "
Explanation
Selects the channel to use .
Explanation
DYNAMIC will not be used .
Only notes picked more strongly than the
DYNAMIC SENS setting will be output .
Only notes picked more softly than the
DYNAMIC SENS setting will be output .
Specifies the picking sensitivity .
The filter will not be used .
Only the region below the cutoff frequency
will be output .
Only the region above the cutoff frequency
will be output .
Cutoff frequency
MIXER
Parameter
Value
STEREO
MODE
PAN L/R
CH A/B
100:0–0:100
BALANC
SPREAD
0–100
Explanation
Channels "A" and "B" will be mixed and output
in stereo .
Channels "A" and "B" will be assigned
respectively to the L and R OUTPUT jacks .
Adjusts the volume balance of channels "A"
and "B . "
* This is shown only if DIVIDER MODE is set
to "DUAL . "
Slightly delays the sound of channel "B" to
make the sound more spacious .
* This is shown only if DIVIDER MODE is set
to "DUAL . "
Advertisement
Table of Contents
