Creating Sounds (Effects); Setting The Effects; Specifying The Divider And Mixer Modes - Boss Audio Systems GT-100 Owner's Manual

Creating Sounds (Effects)

Setting the Effects

Use the left and right displays and knobs [1]--[8] to edit the settings
of the internal effects.
Reference
For details on the basic procedures for manipulating effects,
refer to "Editing: Editing the Effects" (p. 16).
Specifying the Divider and Mixer
Modes
Within the effect chain, the point where the signal is split into
channels "A" and "B" is called the "divider, " and the point where the
two signals are recombined is called the "mixer. "
You can use the divider to switch between channels "A" and "B, " to
assign strongly picked notes and softly picked notes to different
channels, or to assign different frequency bands of your guitar
sound to different channels.
The mixer lets you adjust the volume balance of channels "A" and "B, "
place them in the stereo field, or slightly delay the sound of channel
"B" to produce a spacious sound.
DIVIDER
Divider settings
1.
Press the [EFFECT] button .
2.
Use knob [4] to select "DIVIDER . "
3.
Use knobs [5]–[8] and the PAGE [ ][ ] buttons to make
settings .
Con-
Parameter Value
troller
Page 1
SINGLE
[5] MODE
DUAL
Single mode settings
If you selected "SINGLE" with knob [5]
Con-
Parameter Value
troller
Page 1
[6] CH SELECT CH. A, CH. B
MIXER
Explanation
Use only one channel, either
"A" or "B. "
Use the two channels "A" and
"B. "
Explanation
Selects the channel to use.
Dual mode settings
If you selected "DUAL" with knob [5]
Con-
Parameter Value
troller
Page 2
OFF
POLAR+
CH . A
[5]
DYNAMIC
POLAR-
CH . A
[6] DYNAMIC
0–100
SENS
OFF
LPF
[7] CH . A FILTER
HPF
CH . A CUTOFF
[8]
100 Hz–2 kHz
FREQ
Page 3
OFF
POLAR+
CH . B
[5]
DYNAMIC
POLAR-
CH . B
[6] DYNAMIC 0–100
SENS
OFF
LPF
[7] CH . B FILTER
HPF
CH . B CUTOFF
[8] 100 Hz–2 kHz
FREQ
Explanation
DYNAMIC will not be used.
Only notes picked more
strongly than the DYNAMIC
SENS setting will be output.
Only notes picked more
softly than the DYNAMIC SENS
setting will be output.
Specifies the picking
sensitivity.
The filter will not be used.
Only the region below the
cutoff frequency will be
output.
Only the region above the
cutoff frequency will be
output.
Cutoff frequency
DYNAMIC will not be used.
Only notes picked more
strongly than the DYNAMIC
SENS setting will be output.
Only notes picked more
softly than the DYNAMIC SENS
setting will be output.
Specifies the picking
sensitivity.
The filter will not be used.
Only the region below the
cutoff frequency will be
output.
Only the region above the
cutoff frequency will be
output.
Cutoff frequency
27