Midi Program Map Bank 0-3; Midi Bulk Dump; Pedal Calibration; Auto Off - Boss Audio Systems GT-100 Parameter Manual

SYSTEM
Parameter Value Explanation
This sets the controller number when operation data from the
footswitch connected to the SUB CTL 1, 2/SUB EXP jack is output
as Control Change messages .
SUB
CTL 1 OFF Control Change messages are not output .
OUT
This sets the controller number when SUB CTL
CC#1–CC#31,
1 pedal operation data is output as Control
CC#64–CC#95
Change messages .
OFF Control Change messages are not output .
SUB
This sets the controller number when SUB CTL
CTL 2
CC#1–CC#31,
2 pedal operation data is output as Control
OUT
CC#64–CC#95
Change messages .
This sets the controller number when operation data from the
expression pedal connected to the SUB CTL 1, 2/SUB EXP jack is
output as Control Change messages .
SUB
EXP OFF Control Change messages are not output .
OUT
This sets the controller number when external
CC#1–CC#31,
SUB EXP Pedal operation data is output as
CC#64–CC#95
Control Change messages .
MIDI PROGRAM MAP BANK 0–3
When switching patches using Program Change messages transmitted by
an external MIDI device, you can freely set the correspondence between
Program Change messages received by the GT-100 and the patches to be
switched to in the "Program Change Map . "
Parameter Value Explanation
This sets the patch number (P01-1 through
U01-1–U50-4,
PC#1–PC#128
U50-4) for the corresponding Program Change
P01-1–P50-4
number .

MIDI BULK DUMP

You can use Exclusive messages to provide another GT-100 with identical
settings, and save effect settings on a MIDI sequencer or other device .
Parameter Value Explanation
SYSTEM System parameter settings
QUICK Settings for User Quick Setting
FROM
U01-1–U50-4 Settings for Patch Number U01-1 through U50-4
TEMP Settings for the patch that is currently selected
SYSTEM System parameter settings
QUICK Settings for User Quick Setting
TO
U01-1–U50-4 Settings for Patch Number U01-1 through U50-4
TEMP Settings for the patch that is currently selected

PEDAL CALIBRATION

You can readjust the [EXP] pedal so that it will operate optimally .
Parameter Value Explanation
Adjusts the sensitivity at which the EXP PEDAL SW will
THRESHOLD
1–16
respond .
30

AUTO OFF

The GT-100 can turn off its power automatically . The power will turn
off automatically when 10 hours have passed since you last played or
operated the unit . The display will show a message approximately 15
minutes before the power turns off .
With the factory settings, this function is turned "ON" (power-off in 10
hours) . If you want to have the power remain on all the time, turn it "OFF . "
* When the power is turned off, any settings you were editing will be lost .
You must save settings that you want to keep .
Parameter Value Explanation
OFF The power will not turn off automatically .
The power will automatically turn off when
AUTO OFF
ON 10 hours have passed since you last played or
operated the GT-100 .

FACTORY RESET

Initializes the GT-100 to its factory-set condition . Refer to "Restoring the
Factory Settings .
Parameter Value Explanation
SYSTEM System parameter settings
FROM QUICK Settings for User Quick Setting
U01-1–U50-4 Settings for Patch Number U01-1 through U50-4
SYSTEM System parameter settings
TO QUICK Settings for User Quick Setting
U01-1–U50-4 Settings for Patch Number U01-1 through U50-4