Table of Contents
Advertisement
EFFECT
GUITAR SIM
Simulation of the characteristics of particular guitar components such as
pickups and different guitar bodies allows you to switch among a number
of different guitar types all while using a single guitar .
Parameter
Value
Selects the type of the guitar simulator .
S g H
H g S
H g HF
S g HLW (HOLLOW)
TYPE
H g HLW
S g AC
H g AC
P g AC
LOW
-50–+50
HIGH
-50–+50
LEVEL
0–100
BODY
0–100
SLOW GEAR
This produces a volume-swell effect ("violin-like" sound) .
Parameter
Value
SENS
0–100
RISE TIME
0–100
LEVEL
0–100
12
Explanation
Changes from a single-coil pickup tone to a
humbucking pickup tone .
Changes from a humbucking pickup tone to
a single-coil pickup tone .
Changes from a humbucking pickup tone to
a single-coil pickup half tone .
Changes a single-coil pickup tone to a hollow
body tone with the body resonance added .
Changes a humbucking pickup tone to a
hollow body tone with the body resonance
added .
Changes a single-coil pickup tone to an
acoustic guitar tone .
Changes a humbucking pickup tone to an
acoustic guitar tone .
Changes a piezo pickup tone to an acoustic
guitar tone .
Adjusts the tone for the low frequency range .
Adjusts the tone for the High frequency
range
Adjusts the volume of the effect sound .
Adjusts the way the body sounds when TYPE
is set to S g HLW, H g HLW, S g AC, H g AC
or P g AC .
The body sound increases as the value is
raised; reducing the value produces a tone
similar to that from a piezo pickup .
Explanation
Adjusts the sensitivity of the slow gear . When
it is set to a lower value, the effect of the slow
gear can be obtained only with a stronger
picking, while no effect is obtained with a
weaker picking . When the value is set higher,
the effect is obtained even with a weak
picking .
Adjusts the time needed for the volume to
reach its maximum from the moment you
begin picking .
Adjusts the volume of the effect sound .
DEFRETTER
This simulates a fretless guitar .
Parameter
Value
SENS
0–100
DEPTH
0–100
TONE
-50–+50
EFFECT LEVEL 0–100
ATTACK
0–100
RESO
0–100
DIRECT MIX
0–100
WAVE SYNTH
This is a synth sound that processes the guitar input signal .
* When you use a wave synthesizer, observe the following points .
• Because of the need to analyze the pitch, chords (two or more sounds
played simultaneously) cannot be played . Be sure to mute all the
other strings and play only one note at a time .
• When you are to play the next string while a certain sound is still
playing, mute the previous sound and then play the next one with
a clear attack . If the unit cannot detect the attack, it may not sound
correctly .
• The sensitivity may vary according to the guitar's TONE knob and
pickup type .
Parameter
Value
Selects a wave type which the synth sound is based .
SAW
WAVE
SQUARE
CUTOFF
0–100
RESO
0–100
FILTER SENS
0–100
FILTER DECAY 0–100
FILTER DEPTH 0–100
SYNTH LEVEL 0–100
DIRECT MIX
0–100
Explanation
This controls the input sensitivity of the
defretter .
This controls the rate of the harmonics .
Adjusts the amount of blurring between the
notes .
Adjusts the volume of the effect sound .
Adjusts the attack of the picking sound .
Adds a characteristically resonant quality to
the sound .
Adjusts the volume of the direct sound .
Explanation
Creates a synth sound with a saw waveform
(
) .
Creates a synth sound with the square
waveform (
) .
Adjusts the frequency where the harmonics
contents of the sound are cut off .
This adjusts the amount of resonance (and
the tone coloration) in the synth sound . The
higher the value, the more the synth tone
coloration is emphasized .
This adjusts the amount of filtering applied in
response to the input .
This sets the time needed for the filter to
finish its sweep .
Adjusts the depth of the filter . When the
value is higher, the filter will change more
drastically .
Adjusts the volume of the synth sound .
Adjusts the volume of the direct sound .
Advertisement
Table of Contents
