Table of Contents
Advertisement
Error Messages (continued):
Displayed Message
## "
#
"
" "
(Continued next page)
Description
The ribbon sensor
detects no or only
sporadic ribbon
supply hub
movement; or the
sensor values may
have changed.
; ;
Note: The
ribbon sensor
calibration can be
performed only
after a Level 2
reset has cleared
the previously
entered values.
The printer has
detected a problem
applying the
printhead heat
strobe.
The printer has
shutdown to allow
the printhead
temperature to
cool.
Possible Solution(s)
1) Ensure that ribbon is
correctly loaded with the
printhead locked down.
2) Check the ribbon supply
and ribbon take up hubs for
obstructions stopping
movement.
3) Ensure that the ribbon
supply core fits snugly on
the ribbon supply hub.
4) Ensure that the media and
paper combination is
correct.
5) Perform a Level 2 Reset
(Section 4.0.6) and then a
Positioning Calibration
(Section 5.2).
Try cycling the printer power
'Off' and 'On'. If the fault
does not clear, call for
service.
Turn 'Off' the printer until
cool to prevent permanent
damage due to an excessive
printhead temperature.
79
Advertisement
Table of Contents
