Table of Contents
Advertisement
Step
Operator Action
10 Proceed according to media
type:
Die-cut stock: remove
approximately six inches
of label material from the
backing and place the
backing under the Sensor
Eye Mark. Lower the
printhead.
Notched stock: place the
notched area in the sensor
and adjust the Sensor Eye
Mark over the notch.
Lower the printhead.
Reflective stock: place
the black mark (face
down) in the sensor and
adjust the Sensor Eye
Mark over the mark.
Lower the printhead.
After the Media Sensor has
been adjusted, do not move
its position.
Using the
increment the Gain
Number. Press the
key to select the new setting
and then record the sensor
reading (the 'yyy' value).
Repeat this process for each
of the 16 Gain Numbers,
recording each value. These
are the TOF Values.
(Continued next page)
Displayed Message
key
-OR-
Comment
'yyy' is a
numerical value
representing the
current sensor
reading.
59
Advertisement
Table of Contents
