Table of Contents
Advertisement
4.1.2
Print Control
HEAT
— —
10 (0-30)
PRINT SPEED
2-12 in/sec
FEED SPEED
2-12 in/sec
REVERSE SPEED
2-6 in/sec
ROW OFFSET
— —
00.00in (0-99.99)
COLUMN OFFSET
— —
00.00 in (0-99.99)
LABEL WIDTH
1.00-4.16 inches
PRESENT DISTANCE
— —
0.00 in (0-4.00)
CUSTOM ADJUSTMENTS These
DARKNESS
XX
(1-64)
ROW ADJUST
XXX DOTS (1-128)
COLUMN ADJUST
XXX DOTS (1-128)
PRESENT ADJUST
XXX DOTS (1-128)
32
Controls the printhead 'burn-time'. See
Section 2.1.1 for more on print quality control.
Controls the rate of label movement during the
printing process; see Appendix C.
Controls the rate of label movement between
printing areas; see Appendix C.
Controls the rate of label movement during
backup positioning for start of print, cutting or
present distance; see Appendix C.
Shifts the vertical start of print position. This
is the user setting for row adjustment.
Shifts the left-justified horizontal start of print
position to the right.
Sets the maximum limit for the printable
surface width. Images or data beyond this limit
will not print; see Appendix C.
Specifies an additional amount to advance the
label after printing. When the next label
format is received, the printer backfeeds to the
start position. Only the last label of the batch
will be presented if the present sensor is not
enabled.
factory
change listed parameters, negating slight
mechanical differences sometimes evident
when multiple printers share the label formats.
Controls the printhead strobe time to fine-
tune the HEAT setting.
Shifts the vertical start of print position
upward in dots to fine-tune the ROW
OFFSET setting; see Appendix C.
; ;
Note: A Positioning Calibration must be
performed before this parameter takes
effect; see Section 5.2.
Shifts both the horizontal start of print
position and the LABEL WIDTH termination
point to the right in dots to fine-tune the
COLUMN OFFSET setting; see Appendix C.
Adjusts the label stopping position in dots to
fine-tune the PRESENT DISTANCE setting;
see Appendix C.
adjustments
independently
Advertisement
Table of Contents
