Factory Default Settings; Web Interface (Username And Password); Lan Device Ip Settings; Isp Setting In Wan Site - PROLiNK Hurricane 9300G User Manual

Factory Default Settings

Before configuring your, you need to know the following default settings.

Web Interface (Username and Password)

Username: admin
Password: admin
The default username and password are "admin" and "admin" respectively.
If you ever forget the password to log in, you may press the RESET button up to
6 seconds to restore the factory default settings.
Attention
Attention

LAN Device IP Settings

IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0

ISP setting in WAN site

PPPoE

DHCP server

DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100

LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.
IP address
Subnet Mask
DHCP server function
IP addresses for
distribution to PCs
Chapter 3: Basic Installation
LAN Port
192.168.1.254
255.255.255.0
Enabled
100 IP addresses continuing from
192.168.1.100 through 192.168.1.199
Hurricane 9300G (802.11g) ADSL2+ Modem Router
The PPPoE function is enabled
to automatically get the WAN
port configuration from the ISP,
but you have to set the
username and password first.
WAN Port
16