PROLiNK Hurricane 9300G User Manual page 103

Bridge Interface
Ethernet
Ethernet1
Ethernet2
Ethernet3
Step 2: Create WAN Interface
Go to Configuration
wanlink is the factory default WAN interface which in service for data/internet access. If your ISP
uses this access protocol, click Edit to input other parameters if needed. If your ISP does not use
PPPoE, you can change the default WAN connection entry by clicking Change.
From the example, 0/40 is used for data/internet and assumes PPPoE is used; click the Edit to
change the VPI/VCI to 0/40.
Click Create to setup up additional WAN interface for video applications. Total of 8 VLAN is
support; therefore, only 8 WAN interfaces can be created in the table.
From the example, PVC 0/33 to 0/39 is assigned for video using 1483 Bridged mode. Check RFC
1483 Bridged and click Next to continue the setup.
Chapter 4: Configuration
WAN ISP
Hurricane 9300G (802.11g) ADSL2+ Modem Router
VLAN Port (Always starts with)
P1 / P2 / P3 / P4
P2 / P3 / P4
P3 / P4
P4
99