The Wash Programme Stops And A Fault Indicator Light Comes On - Miele W 360 WPS Operating Instructions Manual

Problem solving guide
– The wash programme stops and a fault indicator light comes
on.
Fault indicator
The buzzer sounds and
the Check drain light
flashes. "– – –"
appears in the display.
The buzzer sounds and
the Check inlet light
flashes. "– – –"
appears in the display.
The buzzer sounds and
the Check inlet and
Check drain lights
flash. "– – –" appears
in the display.
The buzzer sounds and
the Soak/Pre-wash or
Rinses indicator light
flashes in the
programme sequence
display. "– – –"
appears in the display.
1
To switch off the fault indicator: switch the washing machine off with the
I-ON / 0-OFF button and turn the programme selector to Finish.
44
Possible cause
The water outlet is
blocked.
The drain hose has been
fixed too high.
The water inlet is blocked. Open the stopcock.
The Waterproof system
has reacted.
There is a fault.
Remedy
Clean the fluff (drain)
filter and drain pump.
The maximum drain
height is 1 m.
Call the Customer
Service Department.
Start the programme
again.
If the fault indicators
occur again, contact the
Customer Service
Department.
1