A Fault Indicator Light Comes On But The Wash Programme Continues As Normal - Miele W 360 WPS Operating Instructions Manual

– A fault indicator light comes on but the wash programme
continues as normal.
Fault indicator
The Check drain light
flashes.
The Check inlet light
flashes.
The Excess detergent
check light comes on.
The Main wash indicator
light flashes in the
programme sequence
display.
The Final spin indicator
light flashes in the
programme sequence
display
The Anti-crease / Finish
indicator light flashes in
the programme
sequence display.
1
To switch off the fault indicator: Switch off the machine with the
I-ON / 0-OFF button and turn the programme selector to Finish.
Possible cause
The drain outlet is
restricted.
The water inlet is
restricted.
The filter in the inlet
hose is dirty.
Excessive foam has
built up during
washing.
There is a fault.
The final spin has not taken place. The machine
detected an imbalance.
The position of the programme selector was altered
after the start of the programme. Turn the
programme selector back to the programme
previously chosen.
Problem solving guide
Remedy
Clean the fluff (drain) filter
and drain pump.
Check whether
– the stopcock is opened
wide enough.
– the inlet hose is kinked.
Clean the filter.
Use less detergent next
time and follow the
recommendation on the
packaging.
Start the programme again.
If the fault indicator occurs
again, contact the
Customer Service Dept.
1
45