The Wash Programme Stops And A Fault Indicator Light Comes On - Miele W 2104 Operating Instructions Manual

Problem solving guide
The wash programme stops and a fault indicator light comes
on.
Problems
The Check drain light
flashes.
The Check inlet light
flashes.
The Check inlet and
Check drain lights are
flashing.
The Soak/Pre-wash or
Rinses indicator light
is flashing.
A To switch off the fault indicator: switch the washing machine off with the
I-On/0-Off button and turn the programme selector to Finish .
34
Possible cause
The water outlet is
blocked.
The drain hose has
been fixed too high.
The water inlet is
blocked.
The filter in the water
inlet hose is dirty.
The water protection
system has reacted.
There is a fault.
Remedy A
Clean the fluff filter and the
drain pump as described in
"Problem solving guide -
Opening the drum door in the
event of a blocked drain
outlet and/or power failure".
The maximum drain height is
1 m.
Open the stopcock.
Clean the filter.
Call the Service Department.
Start the programme again.
If the fault indicators occur
again, contact the Service
Department.