The Wash Programme Stops And A Fault Indicator Light Comes On - Miele Allerwash W 2584 WPS Operating Instructions Manual

Problem solving guide
The wash programme stops and a fault indicator light comes
on.
Problem
The buzzer sounds and
the Check drain light
flashes. "– – –" appears
in the display.
The buzzer sounds and
the Check inlet light
flashes. "– – –" appears
in the display.
The buzzer sounds and
the Check inlet and
Check drain lights are
flashing. "– – –" appears
in the display.
The buzzer sounds and
the Soak/Pre-wash or
Rinses indicator light is
flashing. "– – –" appears
in the display.
A To switch off the fault indicator: switch the washing machine off with the
I-On/0-Off button and turn the programme selector to Finish .
40
Possible cause
The drain outlet is
blocked.
The drain hose has
been fixed too high.
The water inlet is
blocked.
The water protection
system has reacted.
There is a fault.
Remedy A
Clean the drain filter and the
drain pump as described in
"Problem solving guide -
Opening the drum door in the
event of a blocked drain outlet
and/or power failure".
The maximum drain height is
1 m.
Open the stopcock.
Call the Service Department.
Start the programme again.
If the fault indicator occurs
again, contact the Service
Department.