The Wash Programme Stops And A Fault Indicator Light Comes On - Miele Softtronic W 418 Operating Instructions Manual

Hide thumbs Also See for Softtronic W 418:
Table of Contents

Advertisement

Problem solving guide
The wash programme stops and a fault indicator light comes
on.
Fault indicator
The Check drain light
flashes.
The Check inlet light
flashes.
The Soak/Pre-wash or
Rinses indicator light
flashes in the
programme sequence.
A To switch off the fault indicator: switch the washing machine off with the I-ON/
0-OFF button and turn the programme selector to Finish .
38
Possible cause
The water outlet is
blocked.
The drain hose has
been fixed too high.
The water inlet is
blocked.
The filter in the water
inlet hose is dirty.
There is a fault.
Remedy A
Clean the fluff filter and the
drain pump as described in
"Problem solving guide -
Opening the door in the
event of a blocked drain
outlet and/or power failure".
The maximum drain height
is 1 m.
Open the stopcock.
Clean the filter.
Start the programme again.
If the fault indicators occur
again, contact the Service
Department.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents