MOTU V4HD User Manual page 101

Bus level
The bus level is the overall volume for the bus
output pair. To access bus level, press the left/right
PAGE buttons until you see Bus Level displayed in
the top row of the LCD (Figure 12-6). The current
bus is displayed in the bottom row. To choose a
different bus, press the left/right CURSOR buttons.
To adjust the overall output volume for the bus,
turn the VALUE knob.
Figure 12-6: Bus level and additional bus settings.
Additional bus settings
You can adjust additional bus settings using the
same basic technique as described above for bus
level. Additional settings include the following:
Bus Mute
The Bus Mute setting lets you temporarily silence
the bus output pair.
Init Bus Mix
The Init Bus Mix setting lets you reset the current
mix. All inputs get reset to unity gain (0 dB), pan
center, etc.
Copy Bus Mix
Copy Bus Mix lets you copy all of the settings for the
currently displayed mix. Turn the VALUE knob to
choose a mix. Push the VALUE knob to copy it. You
can then paste the settings to another mix as
explained below. The word Copied appears briefly
to confirm that the mix settings have been
successfully copied.
F R O N T P A N E L L C D P R O G R A M M I N G
Paste Bus Mix
After you copy mix settings (explained above),
Paste Bus Mix lets you paste the copied mix settings
to another mix. Turn the VALUE knob to choose a
mix. Push VALUE to paste. The word Pasted
appears briefly to confirm the paste. The following
mix parameter are included in the paste operation:
Gain, Pan, Solo, Mute and stereo pairing. The
following mix parameters are not pasted: Bus
output, Bus mute and Bus gain.
Save/Name Preset
The Save/Name Preset setting lets you name and
save up to four separate V4HD presets. A preset
holds all of the current CueMix DSP mix settings
for all 16 mix busses. Setup parameters are not
included. The name can have up to 12 characters.
Here is a summary of how to name and save a
preset:
To do this:
To change the currently flashing
character
To move to a different character
To save the preset
Load preset
After you've saved one or more presets, Load Preset
lets you recall them. Turn the VALUE knob to
choose a preset. Push VALUE to load it. The word
Loaded appears briefly to confirm the operation.
Do this:
Turn the VALUE knob
Press the CURSOR buttons.
Push the VALUE knob. If you
are asked to replace existing pre-
set, push VALUE again to
replace it, or turn it to select a
different preset.
101