Scsiselect Default Settings - Adaptec AAA-133U2 - AAA 133 RAID Controller Hardware Manual

Downloaded from www.Manualslib.com
AAA-130U2 Series Installation and Hardware Guide
SCSI Select Default Settings
The SCSISelect default settings for the AAA-131U2/133U2, listed in
the table below, are appropriate for most systems. If you want to
view and/or change the current settings, or if you would like to for-
mat or verify a disk, see Starting the SCSISelect Utility on page A-3.
Detailed descriptions of each setting begin on page A-5
SCSI Select Option
SCSI Bus Interface Definitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Channel A:
ULTRA2-LVD/SE Connector
Fast/Ultra-SE Connector
Channels B & C:
(AAA-133U2 only)
SCSI Device Configuration
Initiate Sync Negotiation
Maximum Synchronous Transfer Rate
Enable Disconnection
Initiate Wide Negotiation
Send Start Unit Command
Include In BIOS Scan
Additional Options
Array1000U2 BIOS
BIOS Support for Bootable CD-ROM
1
If Initiate Wide Negotiation is set to No, this setting is not available.
2
If Initiate Wide Negotiation is set to No, the default setting is 40.0.
A-2
manuals search engine
.
Available Settings Default Settings
0-15 7
Enabled/Disabled Enabled
Auto/Enable/Disable Auto
Enable/Disable Enable
Enable/Disable Enable
Yes/No Yes (Enabled)
1 1 2
80.0 , 53.3 , 40.0, 80.0
32.0, 26.6, 20.0,
16.0, 13.4, 10.0
Yes/No Yes (Enabled)
Yes/No Yes (Enabled)
Yes/No Yes (Enabled)
Yes/No Yes (Enabled)
Enabled/Disabled Enabled
Enabled/Disabled Enabled