Installing The Array1000U2 Driver For Novell Netware; Installing The Driver When Installing Netware - Adaptec AAA-133U2 - AAA 133 RAID Controller Hardware Manual

Downloaded from www.Manualslib.com
AAA-130U2 Series Installation and Hardware Guide
Installing the Array1000U2 Driver for Novell
NetWare
To begin driver installation, see either Installing the Driver When
Installing NetWare on page 5-2, or Installing the Driver When NetWare
is Already Installed on page 5-7.
Note:
We recommend that you install your Novell NetWare
operating system on a fault-tolerant array (RAID 5, 1, or
0/1) to take advantage of the redundancy and performance
features of the array.

Installing the Driver When Installing NetWare

To install the cda1000h.ham driver when you are installing
NetWare, follow the instructions below for the version of NetWare
you are installing.
Note:
The instructions below assume your CD-ROM is
connected to the AAA-131U2/133U2. If your CD-ROM is
not connected to the AAA-131U2/133U2 (for example, con-
nected to an IDE controller), you will need to include com-
mand lines in the config.sys and autoexec.bat files similar to
those described below. Refer to the documentation for the
adapter the CD-ROM is connected for the appropriate
command lines.
NetWare 4.11 and 4.2
Follow these instructions only if you are installing NetWare 4.11 or
4.2 for the first time:
1
Create a DOS partition and install DOS on your system.
2
Copy the aspi8u2.sys and aspicd.sys files from the \dos direc-
tory on the Adaptec Array1000U2 Family Manager Set driver
disk to a directory (e.g., c:\scsi ) on your hard disk.
5-2
manuals search engine