Installing The Driver When Sco Unixware Is Already Installed - Adaptec AAA-133U2 - AAA 133 RAID Controller Hardware Manual

Downloaded from www.Manualslib.com
8
When SCO UnixWare installation is complete, install Adaptec
CI/O Management Software. Refer to the Adaptec CI/O Man-
agement Software User's Guide for instructions on installing and
using the software.

Installing the Driver When SCO UnixWare is Already Installed

To update or install the cda1000 driver on a system where SCO
UnixWare is already installed, follow the instructions below:
1
At the system prompt, type the following and press Enter:
pkgadd -d diskette1
2
Follow the instructions onscreen to insert the HBA disk (the
Adaptec Array1000U2 Family Manager Set driver disk for SCO
UnixWare) into your floppy disk drive and press Enter.
3
When prompted to select packages, select all packages (press
Return). The package is loaded into your SCO UnixWare oper-
ating system.
4
When the package has loaded, you may be prompted to install
the disk again. Do not reinsert the HBA disk (Adaptec
Array1000U2 Family Manager Set driver disk for SCO
UnixWare). Instead, type q (quit) and press Enter.
5
Shutdown or reboot the system.
6
When prompted to rebuild the kernel, select go.
7
When driver installation is complete, install Adaptec CI/O
Management Software. Refer to the Adaptec CI/O Management
Software User's Guide for instructions on installing and using
the software.
manuals search engine
Installing the Software Driver for SCO UnixWare
6-3