Installing The Driver When Netware Is Already Installed - Adaptec AAA-133U2 - AAA 133 RAID Controller Hardware Manual

Downloaded from www.Manualslib.com
18
Remove the disk from your floppy disk drive.
19
Select Continue.
20
Follow the procedures in your NetWare documentation to
complete the installation.
21
When installation is complete, restart the system.
22
At the DOS prompt ( c:\ ), change to the c:\nwserver directory
and enter
server
23
At this point, install Adaptec CI/O Management Software
from the server console. Refer to the Adaptec CI/O Management
Software User's Guide for instructions on installing and using
the software.

Installing the Driver When NetWare is Already Installed

To update or install the cda1000h.ham driver if NetWare is already
installed, follow the instructions below for the version of NetWare
you have installed.
NetWare 4.11 and 4.2
1
Copy the cda1000h.ham file from the Adaptec Array1000U2
Family Manager Set driver disk into the server's startup direc-
tory (e.g., c:\nwserver ) on your hard disk.
Note:
For NetWare 4.11, the cda1000h.ham file is in
a:\netware\v4_1x . For NetWare 4.2, the cda1000h.ham
file is in a:\netware .
2
If necessary, modify the load command line in the startup.ncf
so that the proper path to the driver is specified. The correct
syntax to load the cda1000h.ham driver is
load [ pathname ]cda1000
manuals search engine
Installing the Software Driver for Novell NetWare
5-7