Adaptec AAA-133U2 - AAA 133 RAID Controller Hardware Manual page 47

Downloaded from www.Manualslib.com
2
Windows NT Boot disk installation: When prompted, insert
disk #2 in your floppy drive. After a few moments you will see
a blue screen. To setup Windows NT now, press Enter and con-
tinue with Step 3 below.
Windows NT Boot CD-ROM installation: When the following
message appears onscreen, press the F6 key and skip to Step 4
below.
Setup is inspecting your computer system's hardware...
3
Press S to skip autodetection of your SCSI host adapter.
4
Press S again to specify an additional device.
5
Press Enter to select Others; insert the Adaptec Array1000U2
Family Manager Set driver disk in your floppy disk drive
and press Enter.
6
The screen displays the adapter drivers supported on the disk.
Select the Adaptec Array1000U2 Family Adapter driver and
press Enter.
7
If you want to add drivers (other than for the AAA-131U2/
133U2), press S and repeat Step 5 for each additional adapter
and insert the appropriate disk provided by the hardware
manufacturer.
8
Press Enter to continue with the Windows NT operating
system setup. Follow the instructions onscreen and in the
Windows NT documentation to complete the installation.
9
When Windows NT installation is complete, install Adaptec
CI/O Management Software. Refer to the Adaptec CI/O Man-
agement Software User's Guide for instructions on installing and
using the software.
manuals search engine
Installing the Software Driver for Windows NT
4-3