Adaptec AAA-133U2 - AAA 133 RAID Controller Hardware Manual page 54

Downloaded from www.Manualslib.com
AAA-130U2 Series Installation and Hardware Guide
15
Select cda1000h.ham and press Enter.
16
When prompted to save existing file c:\nwserver\nbi.nlm , select
No.
17
When prompted to save existing file
c:\nwserver\nwpaload.nlm , select No.
18
When prompted to save existing file c:\nwserver\nwpa.nlm ,
select No.
19
When prompted, select Select/Modify driver parameters.
20
Enter a valid slot number, then press Enter to save field data.
21
Press F10 to save parameter settings.
22
When prompted, select Save parameters and continue.
23
Select No when prompted to select an additional disk driver.
24
Select Continue Installation.
25
When NetWare installation is complete, install Adaptec CI/O
Management Software from the server console. Refer to the
Adaptec CI/O Management Software User's Guide for instructions
on installing and using the software.
Note:
To load the driver automatically at server bootup,
make sure the startup.ncf file includes the load command
line for the cda1000h.ham driver. (If you also have an
Adaptec host adapter that uses the Adaptec aic78xx.dsk
driver, make sure the driver loads after the cda1000h.ham
driver.)
5-4
manuals search engine