Installing The Array1000U2 Driver For Windows Nt; Installing The Driver When Installing Windows Nt - Adaptec AAA-133U2 - AAA 133 RAID Controller Hardware Manual

Downloaded from www.Manualslib.com
AAA-130U2 Series Installation and Hardware Guide

Installing the Array1000U2 Driver for Windows NT

To begin driver installation, see either Installing the Driver When Install-
ing Windows NT on page 4-2, or Installing the Driver When Windows NT
is Already Installed on page 4-4.
Note:
We recommend that you install your Windows NT
operating system on a fault-tolerant array (RAID 5, 1, or
0/1) to take advantage of the redundancy and performance
features of the array.

Installing the Driver When Installing Windows NT

To install the cda1000.sys driver when you are installing Windows
NT, follow these steps:
Note:
During Windows NT installation, if your system
configuration has multiple arrays and/or single drives,
Windows NT limits the size of the system partition you can
create to 1 GByte. To work around this 1 GByte limitation,
see Windows NT 1 GByte Partition Limitation on page 4-5.
1
Start your system with the Windows NT Boot disk in the
floppy disk drive or the Windows NT Boot CD-ROM in the
CD-ROM drive.
Note:
When using a SCSI CD-ROM drive to install
Windows NT from the bootable CD-ROM, make sure
BIOS Support for Bootable CD-ROM is enabled in
SCSISelect.
4-2
manuals search engine