Installing The Array1000U2 Driver For Unixware; Installing The Driver When Installing Sco Unixware - Adaptec AAA-133U2 - AAA 133 RAID Controller Hardware Manual

Downloaded from www.Manualslib.com
AAA-130U2 Series Installation and Hardware Guide

Installing the Array1000U2 Driver for UnixWare

To begin driver installation, see either Installing the Driver When
Installing SCO UnixWare below, or Installing the Driver When SCO
UnixWare is Already Installed on page 6-3.

Installing the Driver When Installing SCO UnixWare

To install the cda1000 driver at the same time you install SCO
UnixWare, follow the instructions below:
1
Insert the SCO UnixWare Installation disk in the floppy boot
drive. Reboot your computer.
Wait for the first SCO UnixWare installation screen and prompt
to appear, then follow the onscreen instructions.
2
When prompted to Install HBA Diskette, first remove the
Installation disk, then insert the Adaptec Array1000U2 Family
Manager Set driver disk for SCO UnixWare into your floppy
disk drive.
3
Select Install HBA Diskette and press F10.
4
If you have additional HBA disks, insert the next HBA disk,
select Install HBA Diskette and press F10.
If all of your HBA disks have been installed, select Proceed
With Installation and press F10. (Do not reinstall the cda1000
HBA disk.)
5
If necessary, enter the DCU (Device Configuration Utility) to
view/change the SCO UnixWare device driver configuration
data; otherwise select Continue With Installation.
6
When prompted, reinsert the HBA disk (Adaptec Array1000U2
Family Manager Set driver disk for SCO UnixWare) that you
inserted in Step 3 above, and press Enter.
7
Follow the onscreen instructions to complete the installation.
Note:
If your installation fails, do not attempt to use the
update installation pkgadd procedure to fix the installation.
Follow the instructions in the SCO UnixWare documenta-
tion and in this document to retry the installation.
6-2
manuals search engine