Table of Contents
Advertisement
Install Modular Connecting Blocks
Install a modular connecting block at each telephone location
Find the modular connecting block from the Cable Extension
Kit and the cable installation tool from the Wiring
Installation Kit.
Choose the location for the connecting block according to
the figure. Cut the cable, making sure you allow at least
4 inches extra.
Fasten the cable to the connecting block as shown in steps A-K, below.
Loosen screw. Remove cover and set aside.
Use cable stripping part of cable installation
tool to remove 2 inches of cable cover.
Thread cable through
center of connecting
block until 1/4 inch
of cable cover shows.
Align cable
in one of
the
notches.
Remove and save
plastic caps
Mount connecting block
with screws or adhesive
b a c k i n g p r o v i d e d .
Mounting
holes
Adhesive
backing
Insert wires in this order left
to right:
white-blue
blue
white-orange
orange
white-green
green
white-brown
brown
Align caps and press them down
firmly until they snap in place.
C u t o f f l o o s e w i r e e n d s n e a r
plastic caps. Make sure no wires
touch each other.
Attach appropriate wiring run
label to connecting block.
Replace cover and tighten
screw.
11
Advertisement
Table of Contents
