Table of Contents
Advertisement
Step 6 Connect Controller To Wiring Runs
Business (4-pair) Wiring
Following the numbers on your wiring run labels, plug one end of a jumper cord into the jack
panel box (see page 7). Then pull the cord through the controller the same way you pulled
the line cords. Now plug the jumper cord into the appropriate jack in a station card in the
controller.
When all the cords are installed, remove any slack from the cords in the controller by gently
pulling down on the cords at the bottom rear of the controller. Secure the cords to the wall or
baseboard, being careful not to pierce the cords.
Customer Convenience Wiring
Pull the controller end of the wiring run through the controller the same way you pulled the
line cords. Then, following the numbers on your wiring run labels, plug the cord into the
appropriate jack in a station card in the controller (see page 14).
When all the cords are installed, remove any slack from the cords in the controller by gently
pulling down on the cords at the bottom rear of the controller. Secure the cords to the wall or
baseboard, being careful not to pierce the cords.
16
Advertisement
Table of Contents
