Table of Contents
Advertisement
F. Connect Telephone Lines to Controller
Remove one line cord for each incoming telephone line from the controller box. Additional
cords and longer cords up to 25' long may be purchased at your phone store or from your
AT&T representative. LABEL EACH END OF EACH CORD WITH A LINE CORD LABEL.
Pull a line cord through the opening in the bottom rear of the controller and then hook it into
the opening in the bottom front. Plug the line cord into a modular jack on the line card of the
controller. The line jacks are numbered on the plastic frame to the left. Then plug the line
cord into the network interface jack for that number. The System Directory label is located on
the back of the panel (front cover). Fill in the telephone number of that network interface
jack. Repeat the procedure for each line.
When all the line cords are installed, remove any slack from the cords in the controller by gently
pulling down on the cords at the bottom rear of the controller. Secure the line cords to the wall
or baseboard, being careful not to pierce the cords.
NOTE: If the distance between the controller and the network interface jack is greater than 7 feet,
purchase D4CE extension cords or new (14' and 25' lengths) line cords.
NOTE: Business (4-pair) wiring (see part 4A on page 8) can also be used to connect telephone lines
to the controller. You will want to use Z610A adapters, one for every four lines, along with jack
panel boxes (one box holds 2 Z610A adapters). Use jumper wire to connect the network interface
to Z610A adapters and the line cord supplied to connect the adapter to the controller line jack.
6
Advertisement
Table of Contents
