Form C Supplemental Instructions: Button Templates - Lucent Technologies PARTNER Advanced Communications System Release 1.0 System Planner Manual

Form C Supplemental Instructions:
Button Templates
There are eight pages to Form C—one page for each type of system phone and
one page for an Intercom Autodialer. Use Form C to record line button assign-
ments and to indicate programming for system telephone buttons that do not
have lines assigned if the programming is to be performed from extension 10 or
11 during system installation. After installation, users can program additional
features using the instructions on their Quick Reference Cards .
A telephone button can be programmed as a line button (to access an outside
line), as an Auto Dial button (to dial a phone number or a PBX/Centrex feature
access code with one touch), or as a dial-code feature button (to access a dial-
code feature with one touch). Line buttons must have status lights; some fea-
tures also require buttons with lights (see "Button Feature Summary").
Using the information from Line Ringing and Line Access Restriction on Form
B2, fill out Form C as follows:
Make as many copies of each page of Form C as you need. Where line and
other button assignments are identical for two or more phones of the same
type, you can use one copy of the form and indicate the extension numbers
sharing the programming in the space provided at the bottom of the form.
Use either the button template (to record the exact location of buttons and
the programming assigned to them) or the Check Desired Features checklist
(to identify features to be programmed), or both. By default, lines are
assigned to buttons in the following order:
PARTNER-34D Telephone
13 14
7 8
1 2
PARTNER-18D and PARTNER-18 Telephones
13 14
9 10
5 6
1 2
15
9 10 11
3 4 5
15
11 12
7 8
3 4
PARTNER-6 Telephone
3 4
1 2
MLS-34D Telephone
13 14
9 10
5 6
1 2
MLS-18D, MLS-12D, and MLS-12 Telephones
13 14
9 10
5 6
1 2
NOTE: On MLS-12D and MLS-12 telephones, only buttons 1 through 10
have lights and can have lines assigned.
MLS-6 Telephone
1 2
Indicate the order in which a line is selected when the user lifts the handset
S
or presses to place a call without first pressing a line or button (Auto-
matic Line Selection) if the order is to be different than the default (outside
lines in ascending numerical order followed by intercom).
12
6
15
11 12
7 8
3 4
15
11 12
7 8
3 4
3 4
8