Avaya PARTNER ACS System Planner Manual page 44

®
PARTNER Advanced Communications System
Required Information Notes
2. Custom DSLAM If your SDSL provider uses a DSLAM not included on
settings the list at right, you must obtain and program the
information in this section to complete the configuration.
Set SDSL speed Allows the 1600 DSL to automatically match the current
1
SDSL speed. Always try the highest speed first.
automatically
Conexant AutoBaud Certain DSLAMs use this mode to negotiate line speed.
1
Mode
1
Manual SDSL speed The static data rate for the SDSL line.
Set Data to FRAMED Leave at default value (Y) unless instructed otherwise
1
by the service provider.
mode (Nokia)
SDSL Interface Mode Copper Mountain DSLAM uses "Magnitude, Sign." All
1
others use "Sign, Magnitude."
(Bit Order)
3. Frame Relay PVC Obtain these permanent virtual circuit settings if your SDSL provider uses the Frame Relay protocol. Remember that separate PVC
settings settings are required for the voice and data connections.
1
DLCI number Identifies the logical channel established over the Frame
Relay/SDSL connection. There is one DLCI for data and
one for voice. The SDSL provider should give you two
numbers.
1
Encapsulation The manner in which headers are assigned to packets.
Differentiates between voice calls and data.
1. Obtained from SDSL provider
2. Obtained from ISP
3. Obtained from customer/LAN VAR
®
PARTNER ACS 1600 DSL Module Planning Checklist
34
Sample values Enter values for current installation
Lucent Stinger
Nokia
Copper Mountain
Paradyne
AccessLan
Set SDSL Speed to Auto
Cycle (Nokia); Set SDSL
Speed to Auto Sense
(Copper Mountain);
SDSL Sync Delay
(Lucent)
Enable/Disable
A value divisible by
8 Kb between 144 Kbps
and 2320 Kbps
Y or N
"Magnitude, Sign";
"Sign, Magnitude"
Voice:
45, 46
Data:
Voice:
Proprietary Voice
DLCI, RFC 1490
Data: