Avaya PARTNER ACS System Planner Manual page 46

®
PARTNER Advanced Communications System
Required Information Notes
5. VoIP settings Obtain these settings if your SDSL provider uses VoIP with the Lucent PathStar or other VoIP voice gateway. These settings are in
addition to the required ATM or Frame Relay settings.
IP address of Notified IP address of the VoIP gateway
1
Entity
IP address for MGCP Media Gateway Control Protocol. This is the IP address
1
of the voice PVC on the 1600 DSL; used for signal
signaling
control.
1
TOS byte value Leave at 7 unless specified by SDSL provider.
IP address for RTP Real Time Protocol. This is also the IP address of the
1
voice PVC on the 1600 DSL; used for controlling the
signaling
voice PVC.
1
TOS byte value Leave at 7 unless specified by SDSL provider.
6. IP Router Settings IP router settings apply to the data PVC only.
SDSL (WAN) port
The public address that external routers use to find the
2
1600 DSL module. Select the data PVC when
address
configuring.
2
WAN port subnet mask Required regardless of transport protocol.
2
Normal/High priority Sets the priority of the data port; leave at normal for data
PVC; set to high if using MGCP voice (VoIP).
Default route (gateway) IP address of the ISP. The address to which the router
2
sends packets it otherwise does not know how to route.
IP address
NOTE:
require a manual setting. The netmask is determined
automatically.
10/100BaseT Ethernet Address for the LAN port of the 1600 DSL module.
3
address
1. Obtained from SDSL provider
2. Obtained from ISP
3. Obtained from customer/LAN VAR
®
PARTNER ACS 1600 DSL Module Planning Checklist
36
The netmask for the default route does not
Sample values Enter values for current installation
192.168.32.2
192.168.32.3
1-7
192.168.32.3
1-7
192.168.32.40
255.255.255.0
Normal/High
192.168.32.2
192.168.32.2