AT&T PARTNER II Release 3.1 Programming And Use Instructions page 125

Valid Entries
1 = Assigned
2 = Not Assigned
3 = Select button (and then press a programmable button to assign Direct
Extension Dial to that button)
Programming
To assign or unassign a Direct Extension Dial button with lights at extension 10:
Press [
1 .
If you want to assign Direct Extension Dial to the first available button on the
2 .
system phone, press [
DXD Button
1 Assigned-Ext10
If you want to unassign Direct Extension Dial, press [
display reads:
DXD Button
2 Not Assigned
If you want to assign Direct Extension Dial to a specific button, press [
The display reads:
DXD Button
3 Select Button
Then press a programmable button with lights to assign Direct Extension
Dial to that button.
3 . Select another procedure or exit programming mode.
4 .
Label the Direct Extension Dial button at extension 10.
Using
To turn Direct Extension Dial on:
Press the Direct Extension Dial button at extension 10.
The light is steady green and Direct Extension Dial is on. If calls are ringing
when Direct Extension Dial is turned on, the calls will be answered immediately
by the system.
To turn Direct Extension Dial off:
Press the Direct Extension Dial button at extension 10.
The green light goes out and Direct Extension Dial is off. Any calls in the
process of being answered by the system will continue to hear the recorded
message and will be prompted to enter a destination extension.
5-42 Direct Extension Dial Button (#113)
] [ ] [ ] [
Feature 0 0 System Program
Next Data
] [ ] [
System Program #
] until the display reads:
Next Data
] [ ] [ ] [ ].
1 1 3
] until the
].
3