Specifications - Evinrude 90 E-TEC Manual

Displacement
Engine Type
Full Throttle Operating
Range
(1)
Power
(2)
Idle RPM in Gear
Idle RPM in Neutral
(2)
Ignition Timing
Emission Control System:
(2)
per SAE J1930
(2)
Fuel Requirements
Oil – Lubricant
– Capacity
Warning Signals
Battery, Minimum
(2)
Spark Plug
Fuses
Fuel Filter
Battery Charging
Gearcase – Lubricant
– Capacity
Power Trim/Tilt – Fluid
Capacity
Propeller
Weight
Sound at Driver's Ear
(LpA) ICOMIA 39.94
Transom Height
(1) Rated following the standards of ICOMIA 28.83, ISO 3046 and NMMA.
(2) Emission Control Information.

SPECIFICATIONS

75, 90 Models
79.1 cu. in. (1296 cc)
In-line, 3 Cylinder, Two-Cycle, E-TEC
75 HP – 4500 to 5500 RPM
90 HP – 4500 to 5500 RPM
75 HP – 75 HP (56 kw) @ 5000 RPM
90 HP – 90 HP (67.1 kw) @ 5000 RPM
700 ± 50
(2)
600 ± 50
Not Adjustable
ECM, E-TEC (Engine Control Module, E-TEC )
87 Pump Posted AKI (90 RON) – Refer to Oil and Fuel on
page 15
TC-W3 NMMA-certified oil or Evinrude/Johnson XD100 oil –
Refer to Oil and Fuel on page 15
2.65 qt. (2.5 l)
Controlled by the outboard's EMM
640 CCA (785 MCA) 12 volt
Refer to ECI Label
Refer to Fuse on page 29
In-line Replaceable
25-Amp, Fully Regulated
Evinrude Ultra-HPF™
L Models – 26 fl. oz. (770 ml)
X Models – 42 fl. oz. (1250 ml)
21 fl. oz. (622 ml)
Refer to Propeller Selection on page 40
L Models – 320 lbs. (145 kg)
X Models – 335 lbs. (152 kg)
76.8 dB(A)
L Models – 19 1/2 to 20 in. (495 to 508 mm)
X Models – 24 1/2 to 25 in. (622 to 635 mm)
S
PECIFICATIONS
45