Evinrude 90 E-TEC Manual page 51

YOUR EMISSION CONTROL WARRANTY RIGHTS AND OBLIGATION
The California Air Resources Board and Bombardier Motor Corporation of America ("Bombardier") are
pleased to explain the emission control system warranty on your 2004 Evinrude E-TEC outboard. In Cal-
ifornia, new outboard engines must be designed, built, and equipped to meet the State's stringent anti-
smog standards. Bombardier must warrant the emission control system on your outboard for the periods
of time listed below provided there has been no abuse, neglect, or improper maintenance of your out-
board.
Your emission control system may include parts such as the carburetor or fuel injection system, the igni-
tion system, and catalytic converter. Also included may be hoses, belts, connectors, and other emission-
related assemblies.
Where a warrantable condition exists, Bombardier will repair your outboard at no cost to you including di-
agnosis, parts, and labor provided that such work is performed by an authorized Bombardier dealer.
Manufacturer's Limited Warranty Coverage
This emission limited warranty covers Evinrude outboards certified and produced by Bombardier for sale
in California, that are originally sold in California to a California resident, or subsequently warranty-regis-
tered to a California resident. The Bombardier U.S. and Canada limited warranty conditions for Evinrude
outboards are still applicable to these models with the necessary modifications.
Select emission control parts of your Evinrude E-TEC outboard are warranted from the date of purchase
by the first retail consumer or the date the product is first put to use, whichever occurs first, for a period
of: 4 years, or for 250 hours of use, whichever occurs first.
However, warranty coverage based on the hourly period is only permitted for outboards equipped with the
appropriate hour meters or their equivalent. If any emission-related part on your engine is defective under
warranty, the part will be repaired or replaced by Bombardier.
Parts covered are:
1. Electrical System
A. EMM (Engine Management Module)
B. Spark Plugs and Wires
C. Ignition Coils
D. Wiring Harness
2. Exhaust System
A. Inner Exhaust Housing
B. Adaptor (Exhaust Manifold)
C. Megaphone (Inner Exhaust)
3. Fuel System
A. Fuel Lift Pump
B. Fuel Supply Pump
C. Fuel Injectors
D. Vapor Separator
E. Fuel Lines, Fittings, and Clamps
C E
ALIFORNIA MISSION
4. Air Induction System
A. Reed Valves
B. Throttle Body Assembly
C. Intake Manifold
5. Oil System
A. Oil Injector
B. Oil Lines, Fittings, and Clamps
6. Sensors
A. Air Temperature Sensor
B. Crank Position Sensor
C. Throttle Position Sensor
D. Water Temperature Sensor
E. Thermostat
7. Gaskets
A. All Emission Component Gaskets
C W
ONTROL ARRANTY
S
TATEMENT
49