Engine Cover Latch; Fuse - Evinrude 90 E-TEC Manual

1) Release port and starboard side engine
cover latches downward. Pull up on the tilt
handle to release the engine cover seal
and remove the engine cover.
1

1. Engine cover latch

2. Tilt handle
2) Remove fuse holder from flywheel cover.
1

1. Fuse

3) Raise flywheel guard from the fittings by
pulling up on the front two fastening tabs.
1. Fastening tabs
2
1
4) Holding the flywheel guard out of the way,
hook the knot of your emergency start cord
into the notch on the flywheel. Wind the
cord clockwise in the flywheel ridge, mak-
ing one and a half full windings with the
cord.
1. NEUTRAL
2. Knot
3. Rope in flywheel ridge
5) Turn key switch ON.
6) From a secure position in the boat, pull
hard on emergency starting cord to start
engine.
CAUTION
Keep everyone clear of your immediate
area when pulling on emergency start-
ing cord, especially behind you.
Repeat procedure, if necessary, until engine
starts.
7) Refasten flywheel guard in place by push-
ing the three fastening tabs back onto the
fittings.
1. Fastening tabs
O
PERATION
2
3
1
1
27