Table of Contents
Advertisement
Trunks
Trunk Assignment
Fo//ow the instructions in the Data Guide
to assign trunks to data-only stations.
Use these instructions to assign trunks to telephones and direct-line
consoles. System trunk assignments to QCCs cannot be changed.
There are five different forms for recording trunk assignments. Prepare one copy
of the appropriate form for each station.
PBX System Form 4a, Analog Multiline Telephone
PBX System Form 4b, Digital/lSDN (MLX) Telephone (the front for the
telephone and the back for an adjunct connected using a Multi-Function
Module)
PBX System Form 4c, Tip/Ring Equipment
PBX System Form 5a, Direct-Line Console (DLC) — Analog
PBX System Form 5b, Direct-Line Console (DLC) — Digital/lSDN (the front for
the telephone and the back for an adjunct connected using a Multi-Function
Module)
Planning Form Instructions
On the front of Form 4a through 5b:
1 . Transfer the user identification from PBX System Form 2a, System
Numbering - Station Jacks to each copy of all telephone forms.
Write the logical ID in the "Logical ID" space.
Write the extension number in the "Extension No." space.
Write the name of the person or the location of the equipment in the
"Person or Location" space.
2 . Locate any "voice/voice" or voice/date" entries in the "Person or Location"
column of Form 2a. Under the "Station Jack Pair" heading on Forms 4a
and 5a:
Check the "Voice Announce to Busy" box or the "Simultaneous Voice
and Data" box to indicate the type of station jack pairs.
Enter the logical ID and extension number under the "Even-numbered
jack" heading.
On the back of Forms 4b and 5b:
3 . Fill in the user identification from PBX System Form 2b, System
Numbering - Digital/ISDN Station Adjuncts for any adjuncts
connected to an MLX telephone using an MFM:
Write the extension number in the "Extension No." space.
Write the name of the person or the location of the equipment in the
"Person or Location" space.
Trunk Assignment 3-43
Advertisement
Table of Contents
