Administering Pool Number And Other Digits Sections Of Ars Tables - AT&T MERLIN 3070 Administration Manual

Administering Pool Number and Other Digits Sections of ARS Tables

To administer the Pool Number and Other Digits sections of each table, follow the
procedure below. Tables 0 through 9 contain specific pool numbers, plus any access
numbers required for an alternate long distance company.
Your system automatically places 9, the number for the main pool, in the Pool Number
section of the Special Numbers Table. You cannot change this entry. If you want a
particular special number to be routed to some other pool, place that special number
in the Area Code/Exchange section of one of your other tables. You can make an
entry in the Other Digits section of the Special Numbers Table, if you need to dial
an access number such as 9 before dialing 0 (Operator).
1. If you have not already done so, enter administration mode by follow-
ing the boxed instructions on page 25.
2. Touch Adm Misc.
The lights next to the administration mode buttons stop flashing, and the
green light next to Adm Misc remains on.
3. Dial the 2-character code #7.
4. Dial the table number (0 through 9).
5. Dial the number (0 through 5) of the entry you want to record.
6. Dial the pool number (9, 890-899) you want to record.
7. Dial any additional numbers needed, such as an access code and an
account code for an alternate long distance company, after the pool
number.
NOTE: Each entry in the table may include up to 20 characters.
Characters permitted: 0 through 9, pause (Hold button), a timed switch-
hook flash (Recall button), and Touch-Tone enable (Transfer button).
#is not permitted. Make sure to enter the required number of pauses
between the access code and the account code for an alternate long
distance company. The average number of pauses required is four, but
you may find that your system works best with more or fewer pauses.
Be sure to add one pause after the account code as well.
8. If you want to remove an entry from a table, perform steps 3 through
5 and then touch Drop.
9. Repeat steps 3 through 7, or perform step 8, for each table entry you
want to administer.
10. To add other digits to the Special Numbers Table, dial the 4-character
code #800 and perform step 7.
11. To remove other digits from Special Numbers Table, dial the character
code #800 and touch Drop.
12. If you have a printer connected to your system for SMDR, you can get
a printout of the complete set of ARS tables. To get a printout, dial the
4-character code #902.
The green light next to Adm Misc flashes.
When the printout is complete, you hear a beep and the green light next
to Adm Misc remains on.
Don't go on to step 13 until you hear the beep, or you will get an in-
complete printout. Don't remove your printout from the printer until you
complete step 13, or your page alignments will be affected.
13. Touch Adm Misc.
The lights next to the administration mode buttons flash again.
Remove your printout from the printer.
14. Continue to administer your system or leave administration mode by
following the boxed instructions on page 25.
5 3