AT&T MERLIN 3070 Administration Manual page 12

Large Administrator/Attendant
Console* in Administration Mode
The large console provides the same features as the small console, but
1.
You set the T/P switch to P to perform system
administration.
2.
You use Adm Tel when assigning lines to voice ter-
minals and assigning voice terminals Dial Access to
Line Pools.
3.
You use Adm Pool when setting up line pools.
4.
Line buttons.
5.
Auto Intercom buttons (10 through 79).
6.
Buttons in this column represent intercom numbers
10-19,40-49, or 70-79, depending on which Shift but-
ton you touch.
7.
Buttons in this column represent intercom numbers
20-29 or 50-59, depending on which Shift button you
touch.
8.
Buttons in this column represent intercom numbers
30-39 or 60-69, depending on which Shift button you
touch.
* For systems with more than 8 lines or more than 20 voice terminals—switch H on control unit is down.
has more line and Auto Intercom buttons.
it
9.
You use this Shift button to use Auto Intercom but-
tons for intercom numbers 10-39.
10.
You use this Shift button to use Auto Intercom but-
tons for intercom numbers 40-69.
11.
You use this Shift button to use Auto Intercom but-
tons for intercom numbers 70-79.
12.
You use Night Service when assigning lines to ac-
tivate extra-alerting devices when the attendant is off
duty.
13.
You use Adm Mist when specifying Touch-Tone or
rotary dialing, assigning allowed-list call restrictions,
and administering other system options.
14.
You don't use Message Status during system ad-
ministration. The light beside Message Status must
be off during administration.
15.
You use Copy to give a voice terminal the same
assignments as one that has already been set up.
16.
You use Call Rstr when setting lines to detect atoll
prefix or area code only and when assigning outward
and toll call restrictions to voice terminals.
11