Using The Pencentra 130; Chapter 2 Using The Pencentra 130; Before Setting Up The Pencentra 130; Setting Up The Pencentra 130 - Fujitsu PenCentra 130 User Manual

Chapter 2

Using the PenCentra 130

This chapter covers the fundamental concepts, basic system operation and use, and
system functions of your PenCentra 130. You should familiarize yourself with this
information before you attempt to operate the system.

Before Setting Up the PenCentra 130

Before you set up your PenCentra 130, there are two very important steps to perform:
• The display screen can be damaged with improper use. Be sure to install one of
the included screen protectors on your system. Reference the data sheet that
accompanies the screen protector for installation instructions.
• The system should be charged for a full 48 hours prior to first using it. The
48-hour period ensures that the main battery pack and the backup battery are
fully charged.

Setting Up the PenCentra 130

Turning the device off and on (suspending/resuming)

The suspend/resume button is used to stop and start the operation of your
PenCentra 130. Suspending system operation with this button does not shut the
system down, it simply "puts it to sleep" until you're ready to use it.
To resume system operation, press the suspend/resume button on the top of the
system (see Figure 2-1). When you press the button, the system immediately "wakes
up" and resumes at the same point as when you suspended operation.
Before Setting Up the PenCentra 130
2
2
2
2-1