Replacing The Pen; Inserting/Removing Pc Cards; Powering The Pencentra 130 - Fujitsu PenCentra 130 User Manual

Replacing the Pen

With use, the pen tip may become worn or may pick up abrasive particles that can
scratch the screen. A damaged or warped tip may not move freely, causing
unpredictable results when using the pen. If your pen exhibits these problems,
replace the pen.

Inserting/Removing PC Cards

There are two PC Card slots in your PenCentra 130. With the system display facing
you, slot 1 is located on the left and slot 2 is on the right (see Figure 2-2). To install a
PC Card, insert it into the selected slot with the label facing towards the screen. The
shutter covering the slot folds into the system as you insert the card. Ensure that the
card is properly seated by firmly pushing it in until it stops. When the card is
properly seated, the ejector button rises to be flush with the system surface.
To remove a PC Card, first ensure that it is not running. Using the back end of your
PenCentra pen, press the ejector button for the card you are removing. When the
button is pressed, the PC Card is ejected from the slot. Gently pull the card from the
slot.
Ejector
Button
PC Card Slot 2
Ejector
Button

Powering the PenCentra 130

The PenCentra 130 can be powered by either its rechargeable battery pack or by AC
power adapter.
PC Card
Slot 1
Figure 2-2 Inserting/Removing PC Cards
Inserting/Removing PC Cards
2
2
2
2-5