Changing The Pen Battery; Replacing The Pen Tip - Fujitsu STYLISTIC Q572 User Manual

Changing the Pen Battery

D
•
O NOT REMOVE THE TIP OF THE PEN TO REPLACE THE BATTERY
REMOVE ONLY THE CAP ON THE TOP OF THE PEN
T
•
HERE IS A RISK OF EXPLOSION IF THE BATTERY IS REPLACED BY AN
INCORRECT TYPE
LOCAL INSTRUCTIONS
The pen contains a AAAA-battery. Before proceeding, be sure to
have a new battery available.
Remove the rear Pen Cap (Figure 13).
1
Remove the battery from the pen barrel.
2
Insert the new battery into the pen barrel in the same
3
orientation as the one that was removed.
Close the rear Pen Cap.
4

Replacing the Pen Tip

With use, the pen tip may become worn or may pick up foreign
particles that can scratch the screen. A damaged or worn tip may
not move freely, causing unpredictable results when using the pen.
If a problem like this should occur, you should replace the pen tip.
Using the pen tip removal tool that was included with your
1
system, pinch the pen tip and pull it from the barrel.
Using one of the new tips that were supplied with your pen,
2
insert the pointed end of the tip into the barrel and push it in
firmly until it is in place
. D
ISPOSE OF USED BATTERIES IN ACCORDANCE WITH
.
33 - Active Digitizer/Touchscreen
;
.
Pen Cap
Pen Barrel
Figure 13. Replacing the Battery
Pen Tip
Pen Tip Removal Tool
Figure 14. Replacing the Pen Tip
AAAA-battery