Triggers the measurement. After the second
measurement the value is adopted. The display flashes
(3). Keep the instrument as horizontal as possible.
Press and hold down this button to trigger
continuous measurement. Sweep the laser up and down
over the ideal horizontal target point.
Press this button to end continuous measurement.
The result is displayed in the summary line, the partial
results in the secondary lines.
Storage of constants/historical storage
Storage of a constant
You can store and recall a frequently used value for
example, height of a room. Measure the desired distance,
press and hold the button until the device beeps to
confirm storage.
Recalling the constant
Press this button once to recall the constant and
make it available for further calculations by pressing
button .
Historical storage
Press this button twice and the previous 20 results
(measurements or calculated results) are shown in
reverse order.
The and buttons can be used for navigation.
Press this button to use a result from the summary
line for further calculations.
Pressing the and buttons at the same time
erases all the values in historical storage.
Timer (self-triggering)
Press this button to set a 5-second time delay.
or
Press and hold down this button until the desired time
delay is reached (max. 60 seconds).
Press to begin the timer. The remaining seconds
until measurement (for example, 59, 58, 57...) are
displayed in a countdown. The last 5 seconds are
counted down with a beep. After the last beep the
measurement is taken and the value is displayed.
The timer can be used for all measurements.
Distance Meter
Tilt measurement
Note
21