Switching On - Barco ULTRA REALITY 7000 R9002810 Owner's Manual

13 DIGI ZOOM
14 FREEZ
15 PIP
16 ENTER
17
Cursor keys
18 BACK
20 PIP ADJUST
21 RC operating indication
22 IR receiver
Table 4-1

4.3 Switching on

How to switch on.
1. Press the power switch to switch on the projector.
The projector starts in standby mode. The projector indication lamp is red and the display indicates ( _ )
When switching back to standby, this will be indicated by ( -- ) on the display.
Starting image projection.
1. Press Stand by key once on the local keypad or on the remote control.
The projector mode indication lamp will be green
During the power on sequence the display shows (L). After that sequence the selected source is displayed ( when no source is
selected, the displays shows a point mark ). (image 4-2, image 4-3)
Projector mode indication
Image 4-2
R5976455 BARCO ULTRA REALITY 7000 30062003
allows a digital Zoom of a part of the image
press to freeze the projected image.
allows to activate the PICTURE IN PICTURE mode
to confirm an adjustment or selection in the MENU.
On the local keypad the ENTER button additionally accesses the PIP window resize function
Cursor Keys on RCU or on the local keypad : to make menu selections or to access the
toolbar.
to leave the selected menu or item (go upwards to previous menu).
allows to select a PiP window and change its configuration on screen
lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
IR receiver
4. Getting started
23